hx324c11t3k4/16 16gb (4gb 512m x 64-bit x 4 pcs.) ddr3-2400 cl11 240-pin dimm kit description hyperx hx324c11t3k4/16 is a kit of four 512m x 64-bit (4gb) ddr3-2400 cl11 sdram (synchronous dram), 1rx8 memory modules, based on eight 512m x 8-bit fbga components per module. each module kit supports intel? xmp (extreme memory profiles). total kit capacity is 16gb. each module kit has been tested to run at ddr3-2400 at a low latency timing of 11-13-14 at 1.65v. the spds are programmed to jedec standard latency ddr3-1600 timing of 11-11-11 at 1.5v. each 240-pin dimm uses gold contact fingers. the jedec standard electrical and mechanical specifications are as follows: document no. 480 7105-001.a00 07/23/14 page 1 specifications 11 cycles ) d d i ( l c row cycle time (trcmin) 48.125ns (min.) refresh to active/refresh 260ns (min.) command time (trfcmin) row active time (trasmin) 35ns (min.) maximum operating power tbd w* (per module) 0 - v 4 9 g n i t a r l u operating temperature 0 o c to 85 o c storage temperature -55 o c to +100 o c *power will vary depending on the sdram used. features ? jedec standard 1.5v (1.425v ~ 1.575v) power supply ? vddq = 1.5v (1.425v ~ 1.575v) ? 800mhz fck for 1600mb/sec/pin ? 8 independent internal bank ? programmable cas latency: 11, 10, 9, 8, 7, 6 ? programmable additive latency: 0, cl - 2, or cl - 1 clock ? 8-bit pre-fetch ? burst length: 8 (interleave without any limit, sequential with starting address ?000? only), 4 with tccd = 4 which does not allow seamless read or write [either on the fly using a12 or mrs] ? bi-directional differential data strobe ? internal(self) calibration : internal self calibration through zq pin (rzq : 240 ohm 1%) ? on die termination using odt pin ? average refresh period 7.8us at lower than tcase 85c, 3.9us at 85c < tcase < 95c ? asynchronous reset ? height 1.827? (46.41mm) w/ heatsink, single sided component continued >> xmp timing parameters ? jedec: ddr3-1600 cl11-11-11 @1.5v ? xmp profile #1: ddr3-2400 cl11-13-14 @1.65v ? xmp profile #2: ddr3-2133 cl11-13-13 @1.6v kingston.com/hyperx
document no. 480 7105-001.a00 page 2 continued hyperx all kingston products are tested to meet our published specifications. some motherboards or system configurations may not opera te at the published hyperx memory speeds and timing settings. kingston does not recommend that any user attempt to run their computer s faster than the published speed. overclocking or modifying your system timing may result in damage to computer components. for more information, go to www.kingston.com/hyperx module with heat spreader module dimensions kingston.com/hyperx
|
